460 Ford Forum banner

manual bell housing

1K views 1 reply 2 participants last post by  Duncan Mach72 
#1 ·
By searching I found out I need 7/16 x14x1 1/4 course thread grade 8 bolts to mount bell housing to engine block,manual trans (NP435),,,,how many bolts do I need to bolt bell housing to motor thankyou
 
#2 ·
6.
On my Lakewood bell I had to use socket head capscrews on the 2 left & 2 right bolts. There was not enough clearance to get a socket on a standard hex head bolt. Plus there was not much space between the Z-bar inner support bracket & the bell so a spanner (wrench) was not going to work.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top