prosandguy
08-15-2006, 10:46 PM
OK, while I don't have dyno #'s as of yet, I do have some proven strip #s so I can advise per those. Just keep in mind, I only run 300ft, so I am not sure how it would translate to 1/4 mile times. This was measured using a formula one of the guys at the track came up with using weight, ET, MPH to figure approx crank HP. Seems to be pretty close, maybe a touch conservative with other known combos there.
DIVE 2 bolt block bored .060 with deck plates, lined honed cam and main bearings.
ARP Main studs
Scat 4.300 crank shaft, Eagle 6.800 H beam rods, Wiseco flattop pistons with dual valve relief.
Hastings "Hellfire" ring set
TFS street heads with max port job by the Mad Porter, 1.8 Ratio Probe roller rockers from Lem Evans
Cometic .040 MLS head gaskets, around 13.5-1 CR
Mad Porter custom solid lifter camshaft 266/277 dur, .639/.644 lift
9 way FMS full roller timing set
FMS "Victor" intake, full port by the Mad Porter
Milodon 10 quart truck oil pan, with HV oil pump
Pro systems 1000 cfm 4150 carb
misc CSR water pump, Heddman husler hedders
Bronco is 4100lbs race ready, best et is 4.89@ 68MPH
According to the formula, we calculate somwhere around 730HP, it runs great, idles around the pits nicely, just a pretty easy build.
DIVE 2 bolt block bored .060 with deck plates, lined honed cam and main bearings.
ARP Main studs
Scat 4.300 crank shaft, Eagle 6.800 H beam rods, Wiseco flattop pistons with dual valve relief.
Hastings "Hellfire" ring set
TFS street heads with max port job by the Mad Porter, 1.8 Ratio Probe roller rockers from Lem Evans
Cometic .040 MLS head gaskets, around 13.5-1 CR
Mad Porter custom solid lifter camshaft 266/277 dur, .639/.644 lift
9 way FMS full roller timing set
FMS "Victor" intake, full port by the Mad Porter
Milodon 10 quart truck oil pan, with HV oil pump
Pro systems 1000 cfm 4150 carb
misc CSR water pump, Heddman husler hedders
Bronco is 4100lbs race ready, best et is 4.89@ 68MPH
According to the formula, we calculate somwhere around 730HP, it runs great, idles around the pits nicely, just a pretty easy build.