Paul Kane: Experimental bloc fill results?

Paul,

Back in http://460ford.com/viewtopic.php?t=3248&highlight=bloc+fill , you mentioned that you were going to be,

"...trying out a 2-part (resin/catalyst) product that is not normally used in this application, but it's physical characeristics (no shrinkage, high temp resistance, etc.) meets the required criteria."

Did I miss your results or didn't it happen :?:
If you did get to it, what did you determine from your experiment/test :?:

Thanks for sharing! -- StickBBF :)

Stick,

Sorry I did not see this post sooner.

I have not yet tried the 2-part resin & hardner. Turns out that the amount provided to me is not enough for a complete block fill or even enough for both cylinder banks where it might fill up far enough to make any measurable difference. When the right project comes along, I'll make use of it and opost the results. Might even buy another package/kit so that I have enough for a real world test.

Paul

Not a problem. Thanks for the reply, Paul!

StickBBF :)