My 460 BBF SN95

I am going to put a 532 stroked P51 headed BB in a 2001 GT Drag Race only.
Now this is the first BBF ford engine I am doing and the first Drag only car I am builing so any and all suggestions are apreciated.

Here is the car when I picked it up, then stripped down pwr washed, stripped even more.

Then I started the through floor subframes. they are 2x3 .083 MS. I am putting in a S&W rollcage so I will finish fitting the subframes when I start laying out the cage.

Here is the rearend that has been sand blasted. Then the QA1 coil overs were test fitted and the rearend put into place to check clearance.

The rear end is a fox length 8.8 strange 31 spline and spool with c clip eliminators with cobra brake brackets.

Tires are 28.10.5 on 10inch rimes with 6.5BS.

looks good man ....keep us updated :)

cool build keep us updated.

skinny kid has a nice motor plate system for the sn95 models.the powerglide is a snug fit mine has about 1/2 in clearance with the btw shield.good luck finding a set of off the shelf headers that will work.

here is my 94 mustang build you mite get a few ideas from it.

http://www.460ford.com/forum/showthread.php?t=121183

I have the Skinny Kid motorplate set. I am going to use a C6/CSR shield, with the rollerized build from Frank.