Kickdown lever thing?

Hello everyone,
I was mocking up everything for my 460 rebuild/stroke in my 1970 Continental, and noticed that the stock kickdown lever doesn't really fit, or have full range of motion with the new intake and carb on the car. I was just hoping a few people could post what they did or used to make their aftermarket intake/carb combos work with the C6 kickdown. The intake is a weiand stealth, the carb is a 4150.

Thanks for any information you can provide!

my new set up doesn t have a kickdown but i know Lokar probably has what u need

I used the Lokar accelerator linkage and cable kickdown when I retrofitted a 460/c-6 into my truck.. Worked great.

+1 on the Lokar!

It uses a cabel & brackets instead of a "lever thing" to connect the carb lenkage to the transmission.

Thanks everyone!

I'll start looking at lokar products this evening!

Thanks again

Here is a pic,Lokar kick down cable
http://i306.photobucket.com/albums/nn258/drsand/SANY0008.jpg

where can you get a kick down lever for the c6.. for some reason mine is missing..i already have the lokar kit.. but no kick down to connect it to..

I just welded a piece into mine. Did lots of measuring, and came up with 2" needed. Added 2" in, and now it's too long. So I'll just cut an inch back out. It's probably easier to use the Lokar stuff, but I'm kind of stubborn.

where can you get a kick down lever for the c6.. for some reason mine is missing..i already have the lokar kit.. but no kick down to connect it to..
any one know?

any one know?


Try a transmission shop, they usually have oodles of them.

You can try this guy.

http://motors.shop.ebay.com/jvhiii/m.html?_nkw=&_armrs=1&_from=&_ipg=

You can try this guy.

http://motors.shop.ebay.com/jvhiii/m.html?_nkw=&_armrs=1&_from=&_ipg=



dont need the kickdown rod i have the lokar setup for that. im talking about the rod that comes out of the trans that the lokar cable connects to.