C4 valve bodies

i have my C4 appart at the moment to carry out a few simple mods and to give it a freshen up and i got to thinking if the std valve body could be modified to reverse shift prn123 pattern

also can replacement valve body separator plates be purchased new ??

Yes it Can. Jay at Broader does a very inexpensive kit that works well

Yes it Can. Jay at Broader does a very inexpensive kit that works well

thankyou will look into it

do you think they will have the valve body separator plate?

thankyou will look into it

do you think they will have the valve body separator plate?

It sure does . Comes with seperator plate , pressure spring drill bit and fairly comprehensive instructions. Is a nice kit . The new sep plate is used and some channels cut in the main body . If you like PM me your email i can show you some pics of one i did.

It sure does . Comes with seperator plate , pressure spring drill bit and fairly comprehensive instructions. Is a nice kit . The new sep plate is used and some channels cut in the main body . If you like PM me your email i can show you some pics of one i did.


how much did this help flair up between 2nd and 3rd

how much did this help flair up between 2nd and 3rd

Not sure what you mean ??? Kit works good ,only thing i had to do was run the band adjustment a little tighter than recommended

Not sure what you mean ??? Kit works good ,only thing i had to do was run the band adjustment a little tighter than recommended


i mean when my c-4 shifts from second to third the motor revs a bit kinda slow getting into 3rd

I'm pretty sure the 2-3 spinup can be corrected by using a aftermarket Servo cover IMO.

Later MaRK.

Definitely use the after-market servo cover, should correct problem

i mean when my c-4 shifts from second to third the motor revs a bit kinda slow getting into 3rd

theres a good little servo mod listed on www.clickclickracing.com