C6 help neededdroppedf100 10-21-2009, 05:13 PM My trans is cracked around the top bellhousing bolt but not quite broke off yet. It needs a rebulid anyhow so should I get another case or have it welded? Also, will a normal shift kit still work with a big cam? I have a full manual now and I hate it plus it still flares from 2nd to 3rd. Frank Merkl 10-21-2009, 06:17 PM get another case , as far as the shift kit ,I've had good luck with B&M kit #40228 but put a spacerplate gasket in and leave the 2-3 checkball in also Frank FAIRMONT MIKE 10-21-2009, 08:24 PM Just out of curiosity Frank, what does the 2-3 checkball do? Thanks in advance. droppedf100 10-21-2009, 09:26 PM get another case , as far as the shift kit ,I've had good luck with B&M kit #40228 but put a spacerplate gasket in and leave the 2-3 checkball in also Frank Ok ill get a new case. Will the 2-3 shift be ok with a big cam? I know its controlled by vacuum. IndyPete 10-24-2009, 08:25 AM I'm never buying another shiftkit again. Get a ready valve body at broaderperformance.com instead! Bolt on and no (little) chance of messing anything up :) Frank Merkl 10-24-2009, 10:18 AM 2-3 will be firm Frank Money-pit 10-31-2009, 03:08 PM If you need the neu/rev switch on the trans make sure you get a case the has the bolt holes for the switch. Some don't have them. droppedf100 10-31-2009, 07:51 PM If you need the neu/rev switch on the trans make sure you get a case the has the bolt holes for the switch. Some don't have them. Wow they had those. I have mine hooked up to the pro stick and the reverse lights come on when I shift into 2nd. |