PDA

driveshaft help

bigjohn2007
11-17-2009, 07:00 PM
is their any way to get a driveshaft for a glide in a mustang without puting the motor and tranny in and measure it and this would be with a big block ford motor.
bosshoss
11-17-2009, 08:14 PM
In my opinion any attempt to make a driveshaft for a combination like that would be nothing less than a WAG until you can at least mock up the engine, trans and rearend.

Plenty of guys have done the same swap and could put you in the ball park but my guess is you would end up doing it twice.

dkp:)
crittersf1
11-18-2009, 06:10 AM
In my opinion any attempt to make a driveshaft for a combination like that would be nothing less than a WAG until you can at least mock up the engine, trans and rearend.

Plenty of guys have done the same swap and could put you in the ball park but my guess is you would end up doing it twice.

dkp:)

Put it together and measure it. No two builds turn out identical!