my 532 Blue Thunder headed motor

Motor, C9 block bored .080, decked and squared, line honed, head and main studs durabond cam bearings. Internals: Scat 6.8 h-beam rods, JE flat top forged pistons, Total Seal rings, Scat 9000 4.3 crank, cleveite h-series rod and mains, Cam Motion custom roller 283/292@.050 .747/.749 112 lobe angle 107 intake center, Comp roller lifters, Melling high volume oil pump, crank scraper. Heads-Blue Thunder Ford port with 2.25 intake, 1.88 exhaust, fully ported and milled to 70cc chambers, total compression 14.2-1. Intake-Weiand tunnel ram ported with Enderle Bird Catcher on methanol. MSD digital 6 with pro billet distributor, D&D custom full length headers 2 1/8 primary 4 inch collector. Should have it fired up in April, any estimates on horsepower? Just curious. Thanks, Chris

Chris, Your set up is very similar to mine except I have A429 CJ heads.I also run a Ron's Terminator on alky. I am making around 850HP. I would guess 875-925HP. It ought to be a stout piece. Good luck!!! :D

have you ran your car yet if so what did it do im getting the same motor pm me plz

PM sent. Chris

did you get it fired yet? Im guessing 875...........

No, went with a totally new build, new Eliminator block, A460 heads, 14-71 SSI blower injected alcohol, 572. Should have it all together in a couple months and will keep everyone posted. Sorry, Chris