460 Ford Forum - Reply to Topic
General Tech A place to discuss general tech regarding chassis, transmission, tires, suspension, non-460, etc

Thread: right rear corner of car sags 1" Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the 460 Ford Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
05-08-2013 09:47 PM
Dakota Boy Here's proof that a blind dog CAN find a bone once in a while:

I installed a leaf spring "helper" on the passenger-side leafs. Then I clipped one of those hard nylon coil spring stiffeners onto the front passenger-side coil. This helped drop the rear driver's side just a bit.

And I'll be danged if the car now doesnt sit just about as good as it ever has.
04-30-2013 08:06 PM
Dakota Boy I know the answer is out there; I just need to find the right guy (or shop).
04-30-2013 01:01 PM
Originally Posted by Gydyup View Post
May not be in the rear, maybe off in front, causing the the corresponding droop in the rear.
Very true! He should also consider checking the distance from the "snubbers" or "jounce kits" to the corresponding metal contact surface an all 4 corners to help determine if the problem lies in the suspension or the body mounts/unibody. This may not work in the rear if the spring rate is soft enough that unibody twist(if any) may cause deflection in the springs. Measuring distances from wheelhouse arches to the ground CANNOT be trusted for "for sure" test results, although it can get you in the ballpark.

All of these checks should be done on an alignment rack in the presence of a well-trained technician at which time he should be able to easily determine the root of the problem. I have seen SO MANY people chase their tails on problems like this when it ended up being wasted front end parts, improper tire pressure, bad alignment(which can cause this by itself), etc. Also, "Real" alignment technicians are VERY VERY hard to find these days! Most guys just put measurements "in the green" not knowing why or the ramifications of such actions.

Ask me if needed, I averaged 8-10 alignments a day while a technician at Firestone and have been in the presence of guys like this.
04-30-2013 11:56 AM
D Pope Put the battery on the other side and see what happens
What's it sit like when you're in the drivers seat?
04-30-2013 11:34 AM
White Lightning It's been my experience that older, used body's, especially the unibody set ups that have had some amount of 'non stock' power fed through them will be bent. Either from actual chassis/body twist or from suspension components being not what they 'should ' be. If you're running leafs in the rear, my suggested fix would be to have the leaves re-arched or add to them as needed to reach the desired ride height. I personally try to stay away from lift blocks (where they'd work, re: spring over axle set ups) because of added leverage to the spring pack and that leads to an asemetrical spring loading scenario which leads to chasing handling gremelins. The battery in the right rear will definately contribute to a sag on that corner. JMHO.
04-30-2013 10:13 AM
Gydyup May not be in the rear, maybe off in front, causing the the corresponding droop in the rear.
04-30-2013 06:37 AM
Dakota Boy Battery is in the right rear corner of the trunk.

'58 Tbirds were unibody cars (no body mounts exist).

There is evidence of a right front fender-bender at some point in this car's past.
04-30-2013 06:36 AM
Gydyup I would put it on a frame machine and have it checked.

What about spring bushings, they are in there arent they
04-29-2013 11:26 PM
TorinoStyle2 Either a missing (rotted) body mount, or perhaps the frame is bent slightly, or something else in the body structure is bent.
04-29-2013 10:09 PM
Dman64 Is there a body in the trunk or a bag of money?lol is the car on a frame, maybe a body mount?


Sent from AutoGuide.com App
04-29-2013 09:55 PM
Dakota Boy
right rear corner of car sags 1"

Car sagged to the right with the old, original leafs.

New leaf springs installed. Car sagged less, but still...
So I flipped them around to rule out a potential issue with one of the springs.
It made no difference; car still sags at the right rear corner.

Front of car sits pretty level (as measured at the top lip of each fenderwell to the floor; difference is 1/4"; with the right side being 1/4" lower).

I tried one of those helper springs on the right rear, but that didnt really do much.

Should I add a leaf to the right side?
This is really wierd.
Only a few people have noticed this issue, but it bugs the heck out of me.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome