460 Ford Forum - Search Results
460 Ford Forum  
Go Back   460 Ford Forum > Search Forums

460Ford.com is the premier 460 Ford Forum on the internet. Registered Users do not see the above ads.
Showing results 1 to 25 of 357
Search took 0.09 seconds.
Search: Posts Made By: stuarta
Forum: Driveline 04-01-2015, 07:14 PM
Replies: 4
Views: 272
Posted By stuarta
I answered in a different forum.

I answered in a different forum.
Forum: Driveline 02-16-2015, 09:21 AM
Replies: 8
Views: 628
Posted By stuarta
Can you install the cooler on the other side of...

Can you install the cooler on the other side of the rad?
Forum: Driveline 01-05-2015, 05:31 PM
Replies: 7
Views: 747
Posted By stuarta
More than one turn is bad. Either the...

More than one turn is bad.

Either the lining is gone or it was never adjusted.

You would be wise to drop the valve body, remove the struts and look at the ends of the band.
Forum: Driveline 01-05-2015, 08:06 AM
Replies: 7
Views: 747
Posted By stuarta
How loose is extremely loose? Lining on the...

How loose is extremely loose?

Lining on the band is very thin.

Drop the pan and look for junk.
Forum: The Auction Block 12-10-2014, 09:00 PM
Replies: 2
Views: 306
Posted By stuarta
What engine?

What engine?
Forum: Driveline 11-11-2014, 09:50 AM
Replies: 6
Views: 899
Posted By stuarta
By that it sounds like the over run clutch has...

By that it sounds like the over run clutch has had the biscuit.


The only way to correct this is a complete tear down.
Forum: Driveline 11-09-2014, 08:34 AM
Replies: 6
Views: 899
Posted By stuarta
Give a few more details. Do you mean if the...

Give a few more details.

Do you mean if the transmission is placed in Low it drives then will shift to 2nd then 3rd if the lever is moved but won't move if starting out in Drive position?
Forum: Driveline 10-17-2014, 08:04 PM
Replies: 14
Views: 996
Posted By stuarta
You must remove the transmission and open it up...

You must remove the transmission and open it up to replace the band so may as well look at seals and clutches while in there.
Forum: Driveline 10-17-2014, 01:06 PM
Replies: 14
Views: 996
Posted By stuarta
You are living on borrowed time. I hope there is...

You are living on borrowed time. I hope there is a bit of lining left or the drum will be ruined.
Forum: Driveline 10-12-2014, 02:24 PM
Replies: 14
Views: 996
Posted By stuarta
Ready for PB&J.

Ready for PB&J.
Forum: Driveline 10-11-2014, 12:06 PM
Replies: 14
Views: 996
Posted By stuarta
Check the band adjustment. The screw is in front...

Check the band adjustment. The screw is in front of the lever. Hold the adjuster and loosen the lock nut. Torque the adjuster to 10 foot pounds and back it off 1 1/2 turns. Still holding the adjuster...
Forum: Driveline 10-01-2014, 01:16 PM
Replies: 4
Views: 871
Posted By stuarta
A tad snug but should be ok.

A tad snug but should be ok.
Forum: Driveline 09-25-2014, 06:16 AM
Replies: 22
Views: 1,495
Posted By stuarta
Ribs are there for added support. The bell...

Ribs are there for added support. The bell housings are different.

Like Greg mentioned. Lincoln transmissions are good but take some invention for a rear mount.
Forum: Driveline 09-15-2014, 09:44 AM
Replies: 20
Views: 1,225
Posted By stuarta
It is not mandatory that a dial indicator be...

It is not mandatory that a dial indicator be used. Feeler gauges work just as well.
I set 6 clutches @ .090 clearance.

What kind of valve body do you have?
Forum: Driveline 09-13-2014, 11:26 AM
Replies: 4
Views: 614
Posted By stuarta
The dipstick should say what is recommended.

The dipstick should say what is recommended.
Forum: Driveline 09-12-2014, 06:05 PM
Replies: 9
Views: 1,292
Posted By stuarta
10 springs is all that is required. Space them...

10 springs is all that is required. Space them out. As long as they aren't all close together.

The over run race is what holds the snap ring.

Piston, race, spring retainer, snap ring.
Forum: Driveline 09-02-2014, 08:54 PM
Replies: 20
Views: 1,225
Posted By stuarta
You can use a lower forward pressure plate...

You can use a lower forward pressure plate instead of the thicker plate.
Forum: Driveline 09-02-2014, 01:12 PM
Replies: 20
Views: 1,225
Posted By stuarta
Use it for a door stop.

Use it for a door stop.
Forum: Driveline 09-02-2014, 10:49 AM
Replies: 20
Views: 1,225
Posted By stuarta
Removing material has an affect on band...

Removing material has an affect on band application.

That much could get you into trouble.

Try it then see how the band fits.


If it were mine I would get a different drum.
Score marks...
Forum: Driveline 07-26-2014, 09:50 AM
Replies: 6
Views: 473
Posted By stuarta
Greg already told you but here is a link.

http://www.tciauto.com/tc/trans-dim
Forum: Driveline 07-25-2014, 11:04 PM
Replies: 2
Views: 291
Posted By stuarta
Return fluid is used for lubrication. Make a...

Return fluid is used for lubrication.

Make a loop.
Forum: The Auction Block 07-18-2014, 08:38 PM
Replies: 6
Views: 860
Posted By stuarta
Over a year.

I would say nobody is interested.
Forum: General Tech 07-18-2014, 08:24 AM
Replies: 5
Views: 672
Posted By stuarta
How much fuel pressure is there? Find...

How much fuel pressure is there?



Find out what the CEL represents.
Forum: Driveline 07-15-2014, 11:43 AM
Replies: 11
Views: 957
Posted By stuarta
Just an ordinary kit is all that is required. ...

Just an ordinary kit is all that is required.


Get the biggest baddest external cooler.

Hook it up in series with the rad cooler.
Forum: Driveline 07-15-2014, 12:44 AM
Replies: 11
Views: 957
Posted By stuarta
Woohoo. Glad it worked. Where are those...

Woohoo. Glad it worked.

Where are those jelly beans you promised?
Showing results 1 to 25 of 357

 
Forum Jump

All times are GMT -5. The time now is 07:16 PM.



Powered by vBulletin® Copyright ©2000 - 2015, vBulletin Solutions, Inc.

Garage Plus vBulletin Plugins by Drive Thru Online, Inc.