460 Ford Forum banner

THE NEW BOSS 429 A441 HEAD IS HERE.........AGAIN

11K views 27 replies 8 participants last post by  BOSS 429 
#1 ·
THE REBIRTH OF THE A441 BOSS 429 HEAD HAS COME TO LIGHT

I WILL BE BRINGING ONE WITH TO OHIO,AND SOME ORG A441 AR HEADS ALSO.

STOP BY ,AND CHECK IT OUT!


WILL BE AVB THRU CIRCLE R

I MAY NOT HAVE TIME TO POST PIC'S TILL AFTER OHIO



THANKS
 
#3 ·
The only real diff is the combustion chamber,

It can be bought with either ehx bolt pattern,std Boss 429,or AR pattern

It will also be avb with either rocker stud pattern, std AR which was stock Boss 429,or can be bought with the jesel pattern.



Thanks to all the people stopped by to check it out at ohio.
 
#7 ·
4250.00 a pair, Bare
 
#19 · (Edited)
That's a question I get asked a LOT. THESE LIKE ALL THE OTHER BOSS 429 HEADS,C9AE,DOAE,A441,ETC WILL FIT ON ANY BLOCK, 18 BOLT OR 10 BOLT

Ive been installing BOSS 429 heads on stock block my self since the early 80's.

they also ALL FIT SVO ALUM BLOCKS,A96,ETC ETC, and yes a stock block


That's for asking ,I don't mind answering

CURIOUS why you ask about C & C blocks in general?
 
#20 ·
Yes, made the same way
 
#21 ·
I thought that a C&C block was the only race block available new. I wasn't sure about what they would fit. I knew you could put B9 heads on a stock block but didn't know if bore sizing came into play. Thanks for the info Rich, now I have to start saving. What about valve covers and intakes? Thanks again.
 
#22 ·
no they are 4.9 bore space,so they will fit eliminator, c &c, and the rest no problem

will also be doing valve covers,but theres lot of those out there that also fit
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top