Hey guys, I know i may be beating a dead horse with this but I simply cannot find any information on the question I have. I have a C6 from 1972 that I am doing the full TCI streetfighter (448800) rebuild on and included with the kit is the TRANS-SCAT kit.
I have followed the instructions and done all of the modifications (springs, plug and 2-3 check ball removal) without issue but have reached the separator plate drilling and I am unsure about what I have come across.
So obviously I drill the top hole that is blocked by the TCI plate (per the instructions), but there is no mention of if anything needs to be done for the hole directly below. Any help is greatly appreciated, thanks!
I have followed the instructions and done all of the modifications (springs, plug and 2-3 check ball removal) without issue but have reached the separator plate drilling and I am unsure about what I have come across.
So obviously I drill the top hole that is blocked by the TCI plate (per the instructions), but there is no mention of if anything needs to be done for the hole directly below. Any help is greatly appreciated, thanks!