460 Ford Forum banner

2003 mustang 460 swap

6K views 6 replies 5 participants last post by  GT Trooper 
#1 ·
I'm a new poster here but have lurked for a long time. But I just wanted to start a little thread on my build. .030 over 460, c6, tubular kmember and a arms, 3" exhaust. I'm posting from my phone so more details later.






 
See less See more
3
#2 ·
cool!

That's a very nice Mustang!

Are the stock valve covers powder-coated "Chrome?" Or?

I've seen a set that had been powder coated or water transfer-ed..Anyway, they looked great especially for "plain" stamped steel covers.

Keep up the work on it it'll be cool especially when its done.
 
#3 ·
cool!



That's a very nice Mustang!



Are the stock valve covers powder-coated "Chrome?" Or?



I've seen a set that had been powder coated or water transfer-ed..Anyway, they looked great especially for "plain" stamped steel covers.



Keep up the work on it it'll be cool especially when its done.

How do you know it's a nice mustang? You can only see the engine bay and right fender. Lol

I like the 99-04 body style as well, I almost did what the OP is doing.

I will be watching this thread, thanks for the pics.
 
#7 · (Edited)
Very nice swap you have going on there! I plan on doing the same in the near future and have a few questions.

Which k-member did you go with?

What headers and do they clear well?

Did you need to change the front springs due to the additional weight?

Did you clear the firewall and trans tunnel without issues?

Thanks,
Emmitt
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top