460 Ford Forum banner

Push rod guides

610 views 1 reply 2 participants last post by  mp40 
#1 · (Edited)
#2 ·
They are the conversion plates/studs that convert the "Sled fulcrum" rockers over to screw in studs.

The Crane cams kit had the special studs with 5/16x18 lower with 7/16x20 top. The plates where designed to use the existing slot in the head and the plates had nylon inserts to utilize non-hardened pushrods. So you could use the stock push rods with the kit.

Unfortunately, the kit wasn't intended for really high spring pressures nor high valve lifts either. So, they are good for really mild cams..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top