don't know ,but in my younger years ,I use to crawl under the car ,slide the trans up on my chest ,bench press it up on the dowels and hold it there with one hand and start the bellhousing bolts with the other hand one each side . Mind you I was much younger then !!!!like 25 years ago!!
Frank
don't know ,but in my younger years ,I use to crawl under the car ,slide the trans up on my chest ,bench press it up on the dowels and hold it there with one hand and start the bellhousing bolts with the other hand one each side . Mind you I was much younger then !!!!like 25 years ago!!
Frank
I try to hook the motor/trans together before dropping 'em in. I did bench press my NP205 transfer case, but I wussed out and got Ellen to start the first bolt from the top. But I was like 40 or sumfin'.
its the truth !!!did it many times !! still pick them up off the floor myself and throw them in the back of my pickup ,mind you my new '08 F150 4X4 the tailgate is higher off the ground and it's making it harder !!!!
Frank
on a bet in my younger years , dead lifted a complete 390 FE ,carb to pan with exhaust manifolds and walked with it 5 ft , won a 40 of Crown Royal and got drunk!!!
Frank
4000 lbs when it slides off the jack onto misc body parts and there's no one close by to assist
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
460 Ford Forum
671.2K posts
35.2K members
Since 2006
A forum community dedicated to Ford big block owners and enthusiasts. Come join the discussion about performance, modifications, horsepower, tuning, build specifications, and more!