460 Ford Forum banner

Using k member spacers in a fox

1K views 2 replies 3 participants last post by  Ron95gt 
#1 ·
I want to use 1 1/2" spacers on my k member to lower the motor I was looking for info on what to use for springs to level out the car I would like go use the stock k member and use stock type springs instead of spending the money on coil over kit do I have to cut stock type springs 1 1/2 to level out car I am using 90 /10 struts also I am putting a flaming river manual steering rack in do I have to do anything with the shaft when I use the spacers thanks
 
#3 ·
If I had to do it again, I wouldn't use the spacers. I have 2" hookers and with the change in height and thus the change in angle for the shaft, we had a terrible time in getting a shaft thru the firewall and hook up. It's not like the hood was gonna shut anyway. lol
We put some coils on over the 90/10's that were on the car.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top