460 Ford Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
219 Posts
Discussion Starter #1 (Edited)
4 bolt Main cap front BOSS 429 and other stuff

4 Bolt cap for front main. Came from BOSS 429. Would be a nice addition to any block. I have 2 of these. RARE original parts !!
P.S. The 2 extra small holes are for dowel pins. Boss blocks are doweled on #1-4

$250 each

Accel dual point dizzy. 30202. It is New Old Stock. Been on a shelf for a long time.


JE Boss 429 pistons .030" Installed but never run. These have BIG domes for high compression. The crown is very thick and they could easily be cut down to flat tops if desired. Come with wrist pins but no clips or rings. These sat in an engine after install for a long time. the engine suffered bad water damage and had to be bored. 4 of the pistons have some discoloration from water sitting on them but I assure you that it is cosmetic only. Pistons are still smooth and you cant catch a finger nail in the dark areas. Discoloration is only on 4 of the crowns, wont hurt anything. Pistons appear to be anodized on the crowns. Will sell for less than half what I paid for my new pistons.

Distributor-$100



Pistons-$650


Always open to trades. Especially looking for a dominator flanged victor intake


Thanks
Aaron
219-405-7354







 
1 - 2 of 2 Posts
Top