460 Ford Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
New to the forum. I just purchased a 79’ F100 on a F250 frame. Has a lot of work done to the engine and trans. Believe it was set up for pulling. My question is regards to studding the heads being that it’s got a 96mm turbo on it. Only running 7pounds on waste gate now. When I go to stud them do I need to reset the rockers or just pull them with the rods and keep them together and re install?
 
1 - 1 of 1 Posts
Top