460 manifold flip?
1 - 4 of 4 Posts
Joined
·
190 Posts
Joined
·
4,607 Posts
Bolts will work, port off-set will not.
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
521 intake questions
Engine TechGuys, I have an in the works 521 and I'm trying to figure out what intake manifold I should use. Engines going in a 70 torino with a c-6 and 3.91 gears. Street /strip car Build as follows: 521 10.7 compression ratio D00E-R heads mild cleanup on exhaust Solid lifter comp cams 34-652-5...- 14
- 2K
-
429 CJ pistons
Engine TechDoes anyone have the Ford part number for the 429 CJ cast pistons? Do they have one valve relief, or two? Photos would be great, also. Thanks in advance.- 15
- 7K
-
Been a long time new 460 project help
Engine TechIt’s been a long time like 10+ years, since I put a 385 series in my old 69 Mustang. So I have a new project and need some motor guidance. This is going in a 59 Tbird. I just came home with a Dove block fresh from the machine shop. Stock pistons, Edelbrock Cam 350-7167 specs: Performer RPM...- 7
- 524
-
1970 Cobra Drag Pack 31 Spline Rear Axle Question
Engine TechAs posted in a previous discussion, I am restoring a 1970 Cobra Drag Pack car which had the whole engine, transmission, and drive line swapped out. I haven't pulled the axles to be sure, but I believe that someone installed a 28 spline axle 9 inch in it's place. The end of the axles have the...- 4
- 164
-
Head gaskets
Engine TechRefreshing my motor, after water in the fuel, and was wondering what head gaskets everybody uses. Felpro 1018, Felpro 520SD, or ? Iron heads, block, and 40 over. Max rpms 6500. C/R ~10.5:1- 1
- 83
Join now to ask and comment!