460 Ford Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
512 Posts
Discussion Starter #1
This is a Victor manifold engine going in a 19ft hydro, play toy. I don't think it did to bad for a conservative build. 2.250 Intake valve, 1.73 stud Mount rocker, Straub Solid roller Custom Cam, 30 degrees timing, 2.25" Dyno Headers

819HP at 6700 RPM
717#/ft at 4900 RPM

660#/ft at 4400 rpm
660#/ft at 6500 rpm
 

·
Registered
Joined
·
3,760 Posts
This is a Victor manifold engine going in a 19ft hydro, play toy. I don't think it did to bad for a conservative build. 2.250 Intake valve, 1.73 stud Mount rocker, Straub Solid roller Custom Cam, 30 degrees timing, 2.25" Dyno Headers

819HP at 6700 RPM
717#/ft at 4900 RPM

660#/ft at 4400 rpm
660#/ft at 6500 rpm


It quit at 6700? heads not ported much?
 

·
Registered
Joined
·
190 Posts
Nice Build

Very impressive for a "conservitive" build! Man those heads make damn good power. Was it just a mild 'clean-up' on the castings or some serious porting?
 
1 - 6 of 6 Posts
Top