460 Ford Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter #1
Narrowest of the factory nine inches, Big bearing ends, Strange 35 spline axles, Strange large dia. drum brakes with offset backing plates, 5/8 studs, no pumpkin inc. Was on my 65 Falcon with Caltrac's, no issues, just went to sheet metal housing while doing mini tubs so don't need this one now. $725. shipping available.
Thanks for looking.
Jeff
 

·
Registered
Joined
·
250 Posts
These are a good width for Ranger or Bronco II as an FYI. I used one from a 57 Ranchero in my Bronco II V8 project and loved it many years ago.
 

·
Registered
Joined
·
128 Posts
Discussion Starter #4
What are the housing and axle flange end to end distances?
All 57-59 Ranchero and wagon housings were 57.25 inches, the same as 65-66 Mustangs.

Standard or Mark Williams spline?
Strange uses standard spline.
 
1 - 4 of 4 Posts
Top