460 Ford Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
235 Posts
Discussion Starter #1
Svo block 4.550 bore it has two sleeves in the back two cylinders but it was fixed and put back together IT WAS RUNNING when taken apart to change to an aluminum block for weight reasons. Low run time on current bore I got this block from a close family friend and I know nothing to be wrong with it. The sleeves should not affect it reaching a 4.600 bore. It is the 18 headbolt block I Just really could use the money right now being that I'm out of work. 1500$ OBO will accept partial trades on certain autometer gauges,msd products,nitrous kits, and 9 inch rear end parts. I am also looking for some slicks around 33/10.5/15. Make offers the worst I can do is say no. Give me a call at 1708 227 9940
 

·
Registered
Joined
·
53 Posts
Hey racinguy, why was this sleeved, any idea? Does it need to be re-sleeved if it goes to 4.60 bore? Any idea how old block is? Thanx
 

·
Registered
Joined
·
235 Posts
Discussion Starter #6
The block I believe is from 2010, but unsure. The motor was running when taken apart and I see no reason for it not to reach 4.600 bore the way it is.
 
1 - 6 of 6 Posts
Top