Joined
·
391 Posts
has anybody ever tried to run the kooks bluethunder headers for a foxbody, with trick flow A heads in a foxbody?
a460 headers
1 - 1 of 1 Posts
1 - 1 of 1 Posts
Join the discussion
Recommended Reading
-
Edelbrock valve placement
Engine TechThe 60669's I am currently working with have the valves seats recessed unnecessarily ( in my opinion ) in relation to the chamber head. I had a set of sbc edelbrocks that was the same. Is this casting / manufacturing variation or design? Looking at other "better" heads I dont see it to the...- 2
- 47
-
FoMoCo · updated
-
351 c heads bolt 429
Engine TechDoes anyone now if 351 Cleveland heads bolt on 429 block- 2
- 73
-
Moony · updated
-
porting dove-c
Engine Techanybody hava a pick or 2 ive just started ground one down to what i think is ok, not to far but smoothed out reasonable well. im not sure how far to go so any info would be great. can post a pic of what ive done so far for comparison if any body wants. looks like a long process so glad i have...- 13
- 2K
-
429 CJ pistons
Engine TechDoes anyone have the Ford part number for the 429 CJ cast pistons? Do they have one valve relief, or two? Photos would be great, also. Thanks in advance.- 21
- 7K
-
521 intake questions
Engine TechGuys, I have an in the works 521 and I'm trying to figure out what intake manifold I should use. Engines going in a 70 torino with a c-6 and 3.91 gears. Street /strip car Build as follows: 521 10.7 compression ratio D00E-R heads mild cleanup on exhaust Solid lifter comp cams 34-652-5...- 14
- 2K
Join now to ask and comment!