460 Ford Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter #1
i purchased this intake only a year ago as New Old Stock. It is gasket matched only. No milling done on sides or bottom. i have about 20 runs on it. only changing because i need a taller intake to get the dragster scoop up over the roll cage. I did tap a fitting into the flat area under where the thermostat goes for a #16an line. easily plugged off. ( or you can have it with the fitting)

225 + shipping.

http://www.servimg.com/image_preview.php?i=5&u=18809856
 
1 - 1 of 1 Posts
Top