460 Ford Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
8,752 Posts
C8ve head milled .050, rough idea on cc

70 to 72 if they have been built a time or two, valve seats are sunk a bit and they started at the typical 76 to 77 cc's.

Figure about 1 cc for every .0055" removed. This is approximate.



SJ
used 2b RHP


:D
 

·
Registered
Joined
·
43 Posts
Discussion Starter #3
Thanks scotty, looking at p51s and kasse suggested milling heads to get compression where I wanted vs a dome piston, said they don't work well with the p51s, very small would be ok
 
1 - 3 of 3 Posts
Top