460 Ford Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter #1
I've got a flat tappet cam and solid lifters for sale. This cam and lifters were broken in as a set and all lifters are numbered with their respective lobe. The cam was broken in on the engine properly and looks great, as do the lifters. Probably about two hours of total run time on them total.

I don't have a lot of information about the brand of lifters or cam. I did measure the lift of the cam to be in the 0.610" range and the duration around 260 degrees at 0.050", when in the motor, but I don't have a C/L or lobe separation. Should have calculated that when I did it but I was swapping to a different cam anyhow and didn't think I'd need it.

$110 shipped anywhere in the lower 48, UPS ground. Paypal only. PM me here if interested, sorry that I don't have more info on the cam but I'm not sure I ever got a cam card from the builder.

Thanks,
Ron

 

·
Registered
Joined
·
302 Posts
I don't use paypal and don't know how to PM,but if cash is good call me-254-541-eight six six five.Jim Kitchen
 
1 - 5 of 5 Posts
Top