460 Ford Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter #1
Since a lot of Cam manufactures have gone out of buisness, who make's the most reliable Cam products? Also, we are thinking of using a billit 4-3/4" crank with a 4-1/2" bore in our A-460 block. This way we will still have plenty of material left. Will this give us as much torqe as a small stroke big bore engine? Any input would be appreciated.
 

·
Registered
Joined
·
330 Posts
There are several very knowledgeable guy's on this site who can custom grind a cam for you based on your combo. Do a little vendor research.
 

·
Registered
Joined
·
10,854 Posts
Just off the top of my head I can think of a few: CompCams, Lunati, Bullit, Crower, Isky, LSM, CamMotion and Crane is again open to sell SOME cam stuff.

With an A460 block I would personally go with no longer than a 4.625" stroke.
 
1 - 4 of 4 Posts
Top