460 Ford Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,170 Posts
Discussion Starter #1
I am wanting to have a short run of parts made on a CNC Mill. The part doesn't have any tricky angles, cuts, ect and should be simple to machine. It's made out of 6061 Aluminum. I have a Solidworks file of it.

So, is anybody on this board a CNC Machinist (an operator could even handle this job :) ). Or, can anybody recommend a shop who does small quantity runs?



Have a good day!
Michael
 

·
Registered
Joined
·
1,419 Posts
I'm not certain, but, David Willingham might be your man. Goes by ProF100 on the board.
 
1 - 5 of 5 Posts
Top