460 Ford Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
127 Posts
Discussion Starter #1
Complete and ready to bolt on C-460 heads with titanium 2.45in. and 1.90ex. valves, five angle intake seat , radius exhaust seat, 340# seat and 900# open pressure. Set of W-W 1.8 shaft rocker assemblies, push rods and modified single four C-460 intake. Heads and intake where done by Ted at Engine Systems in Tucker, GA. These components came off a 615 inch test engine that made 1090HP and later made 1130HP after the intake mods. Package $6,500, will not separate. E-mail address is -> [email protected] Phone (901)268-6348 Thanks Jim
 
1 - 1 of 1 Posts
Top