460 Ford Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
294 Posts
Discussion Starter #1
hey i am looking at building an engine for a pulling truck, and i am trying to decide which connecting rod to go with. i was going to but an oliver in it but i can save like 600 bucks and go with a scat h beam with arp 2000. i just want to make sure that it is gonna hold up. i have always used the scat h beam with out any problems but i just want this one strong for some rpm
 

·
Registered
Joined
·
1,102 Posts
need way more info
what are your intended rpm's
tell use all about your motor and class you plan to run
 

·
Registered
Joined
·
294 Posts
Discussion Starter #3
i want it good for just a tad over 8000 but im not saying thats were im gonna run it but i want it to be able to. it will be a460 headed engine what else u need
 

·
Registered
Joined
·
294 Posts
Discussion Starter #5
alright well i havnt actually bought anything yet, but cubes will be right around 500, used in 2wd truck pulling. crank will prob be a forged scat, pistons will be custom.
 
1 - 6 of 6 Posts
Top