Joined
·
1,560 Posts
Got a set here but can't seem to find any info on them. Are they like the 134M's ?
Federal Mogul 7075m main bearings
1 - 3 of 3 Posts
Joined
·
10,854 Posts
NO ... the metalurgy and width are different.
They are wider and use aluminum matrix instead if tri-metal.
EDIT: They have different characteristics.
Joined
·
1,560 Posts
Thanks Randy, the width is what I was concerned about.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Edelbrock valve placement
Engine TechThe 60669's I am currently working with have the valves seats recessed unnecessarily ( in my opinion ) in relation to the chamber head. I had a set of sbc edelbrocks that was the same. Is this casting / manufacturing variation or design? Looking at other "better" heads I dont see it to the...- 2
- 40
-
FoMoCo · updated
-
351 c heads bolt 429
Engine TechDoes anyone now if 351 Cleveland heads bolt on 429 block- 2
- 70
-
Moony · updated
-
porting dove-c
Engine Techanybody hava a pick or 2 ive just started ground one down to what i think is ok, not to far but smoothed out reasonable well. im not sure how far to go so any info would be great. can post a pic of what ive done so far for comparison if any body wants. looks like a long process so glad i have...- 13
- 2K
-
429 CJ pistons
Engine TechDoes anyone have the Ford part number for the 429 CJ cast pistons? Do they have one valve relief, or two? Photos would be great, also. Thanks in advance.- 21
- 7K
-
521 intake questions
Engine TechGuys, I have an in the works 521 and I'm trying to figure out what intake manifold I should use. Engines going in a 70 torino with a c-6 and 3.91 gears. Street /strip car Build as follows: 521 10.7 compression ratio D00E-R heads mild cleanup on exhaust Solid lifter comp cams 34-652-5...- 14
- 2K
Join now to ask and comment!