460 Ford Forum banner

1 - 20 of 25 Posts

·
Registered
Joined
·
1,262 Posts
Discussion Starter #1 (Edited)
new ford racing sfi dampner $185 sold thanks bryan
new scat sfi flexplate ext. balance$35
old style A460 single 4bbl intake unported new intake never bolted on,had runners slabbed on top to allow for extra porting. is usable as is ready to bolt on$150
hawk main girdle no hardware just girdle $25
everything + shipping.
5000 stall for a turbo spline glide etc.,balloon plates,has full circular mounting ring heavy duty stuff $250
canton full length chassis drag pan with pickup,has a few trap doors in it,will fit A460 block$125
big shot nitrous plate,plate only $30
D1VE block cleaned and soniced will take up to a .110 overbore $150
D1VE block cleaned not soniced $100
D1VE block .030 needs honed and cleaned$100
bbf set of wide cam bearings $40
bbf cal custom finned alum valve covers.$100
older mallory tach works,faded dial $25
new in box hatchet counterweight/spacer $40
 

·
Banned
Joined
·
2,451 Posts
Pics of the pan?
 

·
Registered
Joined
·
2 Posts
bbf cal custom finned alum valve covers.$100

Got a picture of those? Are they taller than stock, to accommodate rollers/ girdles?
 

·
Registered
Joined
·
1,262 Posts
Discussion Starter #11
heres the intake,it is unported all stock,the ports were built up for the heads i had,the stk tunnel ram fit but the single4 didnt,this was a new intake,has been millled for clean up purpose only. is usable as is or you could grind it down to to pretty it up its up to you lol!
 
1 - 20 of 25 Posts
Top