460 Ford Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
206 Posts
Discussion Starter #1
My flexplate is shot (ring gear is worn) 460/C6. I saw a new flexplate on e-bay for about 30 bucks and shipping from some company in California. The e-bay flexplate is solid as opposed to mine which is more open. The e-bay flexplate has 164 ring gear teeth and is internally balanced. My old plate is also internally ballanced. Will this flexplate fit? I know I should have provided more info but I am at work and cannot access e-bay from here. The e-bay flexplate is listed under 460/parts/flexplate.
 

·
Registered
Joined
·
68 Posts
William-in-Atlanta said:
My flexplate is shot (ring gear is worn) 460/C6. I saw a new flexplate on e-bay for about 30 bucks and shipping from some company in California. The e-bay flexplate is solid as opposed to mine which is more open. The e-bay flexplate has 164 ring gear teeth and is internally balanced. My old plate is also internally ballanced. Will this flexplate fit? I know I should have provided more info but I am at work and cannot access e-bay from here. The e-bay flexplate is listed under 460/parts/flexplate.
I bought a Scat on ebay for mine that was about $30 bucks and it fit and works fine! It was also sfi approved.
 

·
Registered
Joined
·
1,170 Posts
I also bought a Scat SFI flexplate off Ebay. If my memory serves me correct, it was from a company out of CA too. Although the motor has ran very little since being installed, I have had no problems with it.

Have a good day!
Michael
 

·
Registered
Joined
·
2,615 Posts
I am also using a Scat flexplate I purchased from Brian Adams at AD Performance. No problems at all with it (although the welds could have looked better).
 
1 - 4 of 4 Posts
Top