460 Ford Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
I've got kind of an odd question here. I'm going to throw my motor on a home made engine test stand so that I can start it up every once in a while until I finish the vehicle it's going in. I was wondering if I can just use a manual transmission bellhousing and the flexplate I have to start the engine with or will the flexplate have too much give to it without it attached to the torque converter?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top