460 Ford Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
168 Posts
Discussion Starter #1
Hi, I have a set of pistons that have only been used for warm ups & a couple trips down the road & back. Never made a pass with them. They are TRW flat top w/one valve pocket (like a CJ piston ) They are forged & look very good. They are balanced. I just took them out & am currently looking for a set I can use with Kasse SCJ aluminum heads. I would need to get them pressed off of the rods. I was planning that for tomorrow, if you want. I'll take $250 + ride w/ rings. Or $300.00 W/D6VE rods with football head rod bolts. The #8 rod spun a bearing but most people wouldn't notice the rod, still I wouldn't take the chance. I will send another rod with them if you want.
Thanks
Ron
 
1 - 5 of 5 Posts
Top