460 Ford Forum banner

1 - 17 of 17 Posts

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #1 · (Edited)
Two Ford nine inch third members for sale. Your choice - $350.00.

1 - 3.00:1 with 28 spline trac-loc and 1330 yoke
1 - 3.70:1 with 28 spline trac-loc and 1330 yoke
 

Attachments

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #4 ·
;)
 

·
Registered
Joined
·
42 Posts
Would you take a 31 spline 3.25 chunk for a trade?
 

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #6 ·
Would you take a 31 spline 3.25 chunk for a trade?
Thanks, but my car is 28 spline and all I need for it is a 2.75 open. If the 3.00 doesn't sell, I might just end up using it instead.
 

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #8 ·
would that 21 spline work in a 72 torino or is the rearend in a torino a 31 spline
I think just about all passenger cars were 28 spline. The 3.25 gearset came out of my 73 Montego GT, and the 3.00's out of a 70's Ranchero. Either will work with a 72 Torino if it has the factory rear end.
 

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #9 ·
Still available
 

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #10 ·
Both chunks are in factory stock used condition with 70-90K miles. 3:00's were pulled from a Ranchero that was never raced. As mentioned above, the 3.25's came from my Montego GT and saw less than twenty 1/4 mile runs.
 

·
Premium Member
Joined
·
9,334 Posts
Carl,

I have a 73 LTD with a 2.75 9" trac lok in it. 28 spline
I am looking for a 3.25 trak lok.

Call me if you want to...



:D
 

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #12 ·
3.25's are still available. :cool:
 

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #14 ·
Update: Keeping the 3.25's, now selling 3.00's and 3.70's.
 

·
Registered
Joined
·
5,483 Posts
Discussion Starter · #16 ·
Still available. Both sets are ready to run. No bearings or anything else needed.
 
1 - 17 of 17 Posts
Top