460 Ford Forum banner

Status
Not open for further replies.
1 - 20 of 24 Posts

·
Registered
Joined
·
667 Posts
Discussion Starter #1 (Edited)
hey guys,

i'm selling my race car and i have a complete 521 less carb and wires. it is unassybled $6000.00 for all or will seperate.

rotating assy., new eagle 4.30 crank (has been internaly ballanced), eagle 6.8 H-beam rods, probe flat tops for scj or p51's, this assy. has been ballanced. comes w/rings,bearings, and gaskets, $1500.00

D1VE block, filled to waterpump holes, .030 w/fresh hone, new cam bearings, oiling mods done, $250.00
Kaase SCJB heads, complete w/jomar girdle, (need freshening) $1500.00
MSD dist., pt. #8580, $150.00 *SOLD*
herbert roller cam pt.#HERCH6H (new) $175.00
Compcams roller lifters, $150.00
Compcams 3/8" pushrods, $50.00
Compcams 1.73 aluminum roller rockers, $125.00*SOLD*
CAT 1.8 stainless roller rockers (new), $125.00 *SOLD*
Pete Jackson, NOISY Gear drive setup, $75.00
Victor intake, 4150 flange, w/fresh bead blast, $200.00 *SOLD*
Motorsports tall valve covers, $100.00 *SOLD*
Moroso 176441 chassis oil pan (new) $175.00
Summit gear reduction starter (new), $125.00
Procomp electric waterpump (new), $100.00
Ford HV oil pump for rear sump (new) $40.00
Summit Sfi ballancer, $75.00 *SOLD*

will consider trades for other ford stuff (fe tri power set up), torque thrust wheels

thanks,
steve

will post pics later
 

·
Registered
Joined
·
667 Posts
Discussion Starter #4 (Edited)
answers

here are the answers to some questions i have received:
-the pusrods are 2 differant lenghths, 8.680 and 8.650, they can be used with 3/8" guide plates
-the crank is cast, the pistons are forged, the bearings are clevite 77's and the rings are mahle
-the cam is part #HERCH6H, .685/.683 lift, adv. dur. 291/303. [email protected] 258/270
-the heads and stud girdle are complete
-the pics of some of the parts are on an engine block used to dummy-up the engine in the car
-Elvis is dead and he aint coming back
 

·
Registered
Joined
·
145 Posts
how many runs on the lifters and what kinda package deal would you do on lifters cam balancer you can pm if youd like
 

·
Registered
Joined
·
715 Posts
What's the part number on the distributor
 

·
Registered
Joined
·
454 Posts
gear drive

steve,is the gear drive quiet or noisy?pat
 
1 - 20 of 24 Posts
Status
Not open for further replies.
Top