460 Ford Forum banner

Status
Not open for further replies.
1 - 14 of 14 Posts

·
Registered
Joined
·
667 Posts
Discussion Starter #1 (Edited)
hey guys,

i traded my race car off this week and i don't need this bb stuff now. it's for sale or i would trade for windsor stuff. stock or stroker i need everything. i'm wanting a good strong street motor not a race motor. i'm also looking for a glass hood for a 66-67 fairlane and a fe 3x2 set up.

-rotating assy. 521" new eagle 4.30 crank, new probe forged flat tops for scj/p-51 1.35ch, eagle h-beam rods, mahle rings, clevite 77 bearings, felpro gaskets, this assy. has been ballanced and is internaly ballanced. $1500.00*sale pending*
-scj heads, roller springs, studs, guide plates, can be run as is or freshened. $1400.00*sale pending*
-jomar stud girdle for scj/p-51 complete. $125.00
-moroso full length chassis pan, no pickup. $150.00
-d1ve block, .030 fresh hone, o-ringed, oiling mods done(lifters NOT bushed), filled to bottom of water pump holes, new cam bearings. $250.00
-Herbert roller cam, $150.00*SOLD*
-electric water pump $100.00*SOLD*
-solid roller lifters $150.00*trade pending*
-HV oil pump for rear sump $40.00
-gear drive timing set up $75.00*sold*
-compcams 3/8" push rods*sale pending*
-Flying toilet set up, 4.1, david cole's last set up, this has EVERYTHING, Also includes primer w/gas tank and pump, vacuum pump, and an extra injection pump, shut off cable. $1600.00

all items are + shipping

thanks,
steve
256-759-8999
 

Attachments

·
Registered
Joined
·
1,115 Posts
I did a deal with Steve Earlier in the year, ALL WENT well! Everything was as described if not more! Good guy!
 
1 - 14 of 14 Posts
Status
Not open for further replies.
Top