460 Ford Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
3,195 Posts
Discussion Starter #1
OK guys... I'm gonna try and sell these heads so I can try and get to the Bash for the rescheduled date...

These heads are virtually identical to the original A-429 heads, they are NOT ported, have 5300 street miles on them before a cam went flat... I cleaned them up, vacuum tested all the valves and they all sealed up nicely... They're ready to bolt on or you can choose to have one of the most competant gurus of your choice do them up for you...

I'm asking $1800.00 SHIPPED anywhere in the lower 48...
AAAAND, as an incentive, I'll offer the buyer their choice of any of the rockers I have listed on here as well, to complete the set...

Come on guys, help me get to the Bash... :D :D









Doug... 8)
 

·
Registered
Joined
·
3,195 Posts
Discussion Starter #3
Not sure on the springs... I checked the cam, and there's no # anywhere on it... I do know it was a solid flat tappet... I'll pull a couple springs today and stick them on my spring tester...





Doug... 8)
 

·
Registered
Joined
·
3,195 Posts
Discussion Starter #4
darrin1999 said:
any idea what the specs are for the springs? or the cam they were matched to?
I pulled a couple springs and checked them, they are 128# on the seat @ 1.850" installed ht.

Just shy of 360# open @ .600 lift. @ 1.250"

Coil bind @ 1.125.

They are a double spring w/o a damper and are a small diameter spring 1.47"



Doug... 8)
 

·
Registered
Joined
·
3,195 Posts
Discussion Starter #5
TTT :wink:



Doug... 8)
 

·
Registered
Joined
·
3,195 Posts
Discussion Starter #7
TTT :D :D :D




Doug... 8)
 

·
Registered
Joined
·
3,195 Posts
Discussion Starter #8
N/M :D :D







Doug... 8)
 

·
Registered
Joined
·
3,195 Posts
Discussion Starter #11
You have a PM Al...




Doug... 8)
 
1 - 11 of 11 Posts
Top