460 Ford Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter #1
Well I've finally got the top loader in and linkages hooked up. Haven't been fooling with the car much lately, but figured I better go ahead and get it done. Being a 71 Mustang, I never did find the factory clutch linkages, go figure :roll: so I decided to go hydraulic. Question is, were do I get the master cylinder for this car? I was going to use a hydraulic throwout bearing also. I think the Mcleod throw out bearing for the small input toploader will work, just need to know what to do from there on. :?:
 
1 - 1 of 1 Posts
Top