460 Ford Forum banner
1 - 3 of 3 Posts

· Registered
7 Posts
Discussion Starter · #1 ·
I am getting ready to have the valve job done on a set of ported D00ER CJ heads. These will be for a .700 lift roller cam - strip only (mostly :wink: ). What are the recommended angles for a 3 angle valve job? I remember reading something on the old forum about a 70 deg top angle but I can't find the thread in an archive search.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.