460 Ford Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5,676 Posts
ISO 8 4.440 pistons w/domes at least +5 1.350 CH .990
ALSO 8 7.0 2.2 .990 connecting rods

If I'm not mistaken, those are going to have to be a custom made piston and rod combo.
I'd suggest talking with Diamond and what ever aluminum rod manufacturer you'd prefer.

If you're looking to put together a 514"/515"/516" combo that will be REV friendly then a Lunati 4.160" 4140 crank and a set of Diamond 40704 pistons and a set of GRP 6.8" aluminum rods will be a good place to start.
Rob
 

·
Premium Member
Joined
·
45 Posts
Discussion Starter #4
Its a typical stroker piston just looking for nos or lightly used peices for my 480 if available and 7 inch bbc rods.....i will check with Racetech also............ Thanks
 
1 - 4 of 4 Posts
Top