460 Ford Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
610 Posts
Discussion Starter #1
I have some JE (747F) gas ported pistons with the rings for a 514. the bore is 4.440 they fit the 6.800 rod on a 4.14 stroke crank. they have very little run time and no nitrous. $400 obo.
 

·
Registered
Joined
·
610 Posts
Discussion Starter #2


pistons are fresh out of the block and have not been cleaned.
rods are not included. :D
 

·
Registered
Joined
·
610 Posts
Discussion Starter #4
These have eight dyno pulls and then about ten passes in my boat. nothing wrong with them i'm just going to c460 heads and bigger C.I. :D

The compression was about 14:1 with .040 head gaskets and 89cc chambers.
 
1 - 7 of 7 Posts
Top