460 Ford Forum banner
1 - 3 of 3 Posts

· Registered
113 Posts
Discussion Starter · #1 ·
Any body have a roberts block that can give me the measurement from pan rail plane to top of #1 main cap at highest point.

Fabricating a one off pan that will just clear front main cap then turn down about the center of the bearing and need to know how tall the 1st main cap is. I have the distance from front seal to rear edge of cap and the rest I can do on the block I have.

Thanks in advance !!
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.