460 Ford Forum banner

Motor angle question?

2050 Views 2 Replies 3 Participants Last post by  mico
Hi, I'm in the process of mounting my motor in my car and I need a little help. I was wondering what the standard or proper angle of my bbf should be? I have motor plates, and I'm trying to figure out if I should have the motor tilted back a degree or 2. Right now its 1* back. Should i go for more like 2* or 3*? This is in a 88 notch mustang.

Thx

Jay
1 - 3 of 3 Posts
post in engine tech will get more response
point the crank at the rear pinion with the axle set at ride height. dont worry about angle
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top