460 Ford Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I got a 429 motor and I wanna swap it and put it n my 08 crown Vic p71 but is it even possible?
 

·
Registered
Joined
·
157 Posts
anything is possible. Just a matter of how much it'll cost and the problems involved. It's not just an engine sway, but pretty much the whole power train. You might want to look at what and how much it would cost to beef up what you have.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
92040
Well this is what I got and I got a old truck with same engine so I wanna use thia cuz it’s bigger than p71 engine an I want higher stock power to build off of an I just wanna know if it’ll run with this engine but good advise I’ve just seen kinda what my p71 motor puts out an I want more lol
 

·
Registered
Joined
·
127 Posts
yes very possible the reality of this coming to floriation will depend on two things

1 how much money will you want to invest

2 what is your ability level and tool selection

but you will need a trans, there will be a lot of fabrication, I have done a lot of swaps like this in fords and in gm
 
1 - 4 of 4 Posts
Top