460 Ford Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2,960 Posts
Discussion Starter #1
I've got a 4150 port-o-sonic intake . It's been extensively ported on .The cloverleaf is opened way up and it's been ported to SCJ intake size on the the intake ports. Heat risers are welded up .It has one intake port that was ground through and welded back up, they did a good job on it, and one intake port has a little epoxy where they cut it a little big on the gasket. this intake should perform really well. $150 shipped to your door in the lower USA
[/img]
 

·
Registered
Joined
·
2,960 Posts
Discussion Starter #2
obo or trade ?
 

·
Registered
Joined
·
2,960 Posts
Discussion Starter #4
I'd say it'd do that easy. I ran a stock one on my Mustang 477 for years ,and it went 6.24 in the 1/8 it was a 3045lb car, so it had to be 650hp or better. This intake has had a ton of porting done to it. Thanks,Dan
 
1 - 5 of 5 Posts
Top