460 Ford Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
Looking at an oiling schematic for the 385 series, I'm wondering if it would be a good idea to increase the size of the lifter crossover gallery size from 5/16 to 1/2 inch on the side that feeds the mains, then drill into the side of the crossover and feed it with the -12 from dry sump pump.

Any thoughs, thanks

Simon

(this is of course assuming the lifters have been bushed and the block is a production block)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top