460 Ford Forum banner

p51 flat tappet

2K views 2 replies 2 participants last post by  528 ford 
#1 ·
Does any one know of a valve spring that sets up at 2.00 for p51 heads for a flat tappet cam? Pressure needs to be around 150# on the seat and 380# open at 1.250. These number come from comp cams specific for their cam. But their spring does not set up at 2 inch installed height. The spring I have now is comp 928 which does not have the pressure at 2 inch. These springs came on the heads new out of the box. So im trying to get my valve spring pressure correct,thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top